Network Setup PIXMA PRO-10 Wireless Connection

Sunday, July 30th 2017. | PIXMA PRO, Setup

PIXMA PRO-10 Wi-Fi Setup

  • Setup PIXMA PRO-10 Wireless Connection

WPS Connection Method
Standard Connection Method
Restore to Factory Setting

Network PIXMA PRO-10 Wireless Connection SetupCanon PIXMA PRO-10 Wireless Connection Setup Paint instructions easy to use PIXMA PRO-10 series Wireless Connections easy-setting how to setup a wireless connection, reset the printer to factory settings. Connection directly from multiple access points (router/hub) and features automatic connection button (WPS). To connect PIXMA PRO-10 allows authorized devices to connect to your network without having to enter a password, proceed to method of connecting devices.

Follow the method probably much the way the settings-easy to connect the PIXMA PRO-10 Printer, while if the access point WPS button, you have advised un tuk select tab [WPS connection method]. When an error occurs on the router does not support WPS that have to provide to get the PIXMA PRO-10 is connected, make sure to go to [the standard connection method] below :

WPS Connection Method

Make sure that you use the method when the button WPS, this problem requires some terms and conditions that must be met.

On the access point WPS button push button is available, please check again the user guide of your device, and if the push-button WPS is not available, menyerankan that to use the instructions in the standard connection method tab. Make sure the network have to use WPA (Wi-Fi Protected Access) / WPA2 security protocol.

Step 1

  1. Make sure that your Printer is turned on
  2. Please suppress/hold the “Wi-Fi” is found on the front of the printer for a few seconds

Step 2

Make sure that the Start button flashes blue, go to the access point, and then press the button “WPS” exist around 2 minutes. The Wi-Fi light (blue) light up on the printer flashing while searching for/linking access point, when printer manages to make a connection to the wireless network, then the blue light stops flashing, while still light up.

Network settings confirmation

Next confirm that sure your printer connects to a wireless network, and get print printer network settings if necessary :

  1. Make sure that the Printer is turned on
  2. Please load (sheets of A4/letter-size plain paper)
  3. Press, hold down [Resume/Cancel] until the power lamp flashes at about 6 times, and then release it
  4. Then the network information page will be printed

Make sure the power supply indicates that Active/SSID-Service Set Identifier (wireless network name) when referring to the mold. If the problem still has not been completed or failed for PIXMA PRO-10 Wireless Configuration WPS after following the guide that we provide, we recommend you to visit the site trusted or the product as more help.

tags: , , , ,