Network Setup PIXMA MP495 Wireless

Thursday, February 23rd 2017. | CANON, Setup

Setting Up PIXMA PIXMA MP495

Wireless LAN/WiFi protected setup

Network Setup PIXMA MP495 WirelessConnection Setup PIXMA MP495 Wireless page printerdriverseries find instructions on how to setup a wireless connection for my Printer PIXMA MP495, follow these step multiple access points, such as a router/hub, feature button automatically labeled connection Wi-Fi Protected Setup. PIXMA MP495 connecting to network without need to enter the security password, quick-easy method of connecting devices. Make sure your router supports WPS.

WPS Connection Method

Follow these steps to resolve the problem of the PIXMA MP495 Wireless LAN/WiFi protected setup to print directly from the Wireless. Be sure to prepare some conditions that must be met to use the WPS button method. Make sure the access point WPS push button required to have physically available. Then please check with your device’s user guide. Your network must use Wi-Fi Protected Access WPA2 security/protocols.

Step 1 requires that your Printer is turned on, the power LED/Light Emitting Diode lights up.

  1. Make sure you press, hold down the “Maintenance” of takes about 5 seconds
  2. LED Fashes

Step 2

  1. Press the “fit to page”
  2. Make sure that the LED flashes, then press the button “WPS” at the access point, it takes about 2 minutes
    (The Wi-Fi Light (blue) on the printer will flash, then this while searching for/linking access point)
  3. When the wireless connection is complete the LED lights in about 3 seconds, then turn into [1]
  4. Make sure that the Wi-Fi light (blue) on the printer is turned on

Important

If there is an error code, and be shown on the LED [E] letter or some other which was followed by a number is not known. Please press “black/colours” button to ignore the error, be sure to mention that you are attending repeat steps 1 and 2.

About a particular error/Error E, 2, 1/Error E, 2, 3

This happens when the wireless connection setup not completed in some time around 2 minutes after pressing the WPS. While also the access point is turned on, when the access point is turned on, turn it off, and turn it back on.

Error E, 2, 3 this happened when some WPS access points detected, wait for some time, then configure WPS settings again. If you have more than one access point, press the button “WPS” on only one access point.

Network settings confirmation

Confirm that the printer is successfully connected to the wireless network, get print network settings of the printer.

  1. Make sure that the printer is turned on
  2. Please try a sheet of A4 or letter-sized plain paper
  3. Press the “Maintenance”, repeatedly until LED Display
  4. Press the button (“Black/color”)

Referring to the mold, then check that the Link is Active, the Status indicates that the Service-Set Identifier SSID (network name) show the name of your wireless network.

WPS setup procedure concluded

Please proceed with installing the software to make the most of Your PIXMA MP495 Drivers, Download Software Canon PIXMA Support.

Note :

If you perform the settings with PIXMA MP495 network requirements, make sure before connecting the machine to the network, that the configuration of the computer, access point or router needs to complete connected to the network. Even a wireless connection. / please contact the canon help for further assistance.

tags: , , , , ,