How to Set Up With Wireless Printer Connection

Thursday, January 29th 2015. | Setup

Connection to Network With Wireless For The Printer

This page is information that we get from Your trust so that the product can help you and set up a network connection for your printer. This guide is to provide information such as:

  • Preparation for Connection
  • Printer Setup
  • Connection Using WPS

Network Connection/ Wireless Connection

Before starting the Setup of your wireless connection to verify that the preparation for the next step connections

  1. Make sure that your printer is turned on and if the power LED lights up

Notes :

  • Convinced that your computer is connected to the access point or wireless router to dimenghubungkan to your printer
  • Configuration of the router function, procedure, setup and network device security settings vary depending on Your system environment. For details, see the manual of Your network devices or please feel free to contact the manufacturer. (Check, if your device supports IEEE 802 .11n, 802.11 g or 802 .11b)
  • If your device is set to the [IEEE 802 .11n only] mode, WEP or TKIP may not be used as security protocol. By changing security protocols for your device to something other than WEP and TKIP or also change the settings to something else [IEEE 802 .11n only]
  • For office, you please contact your network administrator
  • Take care when added to connect to networks that are not protected with security measures, since there is a risk of revealing data such as your personal information to other parties
  • An [Ad-hoc connection] that establishes a direct connection to a computer via a wireless connection without an access point (not supported), then be sure to prepare an access point

Printer Setup

  1. Press and hold the button click maintenance on the printer which is available for about 6 seconds
  2. Make sure that the LED on the drive flashes

Connection Using WPS

  1. Press the page button is suitable for
  2. Be sure sure that flashes LED as shown in the illustration above, and then press and hold the WPS button on the access point in time about 3 minutes
  3. For details on pressing the button [WPS], refer to the manual of your access point so that the Wi-Fi light (blue) on flashes printer while searching for or linking to an access point
  4. When the wireless connection is complete, the LED lights up in about 3 seconds, and then turn into (1). Make sure that the Wi-Fi light (blue) on the printer will turn on

Then setup the network connection process has been completed.

Troubleshooting

WPS

  • E > > 1 2

With the possibility of this error appears when the setup of a wireless connection is not completed within 2 minutes after pressing the WPS button.

Check the network devices (routers, etc) is enabled, and if the network device is already activated, then deactivate it, and then turn it back on

  • E > > 2 3

The screen will appear when the number of the access point has been detected. And wait a few moments, then configure WPS settings again. Press the WPS only one access point You

  • E > 2 > 4

Screen appears when an error occurs. And check with Your access point settings, then WPS settings again configure.

For details on how to check the settings of the access point, please refer to the manual supplied with the access point or contact the manufacturer

Configure WPS settings

  1. Press the color on your printer
  2. Press and hold down the maintenance on the printer you are about 5 seconds
  3. Make sure that the LED will lit flashes

tags: , , , ,